How to deactivate AirDry
AirDry improves the drying results with less energy
consumption.
While the drying phase operates, the
device opens the appliance door. The
door is then kept ajar.
By default, AirDry is activated with all programmes
excluding
(if applicable), but it is possible to
deactivate it.
Make sure the appliance is in user mode.
1. Press
.
The indicators:
and
are off. The indicator
still flashes.
The indicator
indicates the current setting. If on =
AirDry is on, if off = AirDry is off.
2. Press
to change the setting.
3. Press on/off to confirm and save the setting.
Caution! If children have access to the
appliance, it is advised to deactivate
AirDry as opening the door may pose a
danger.
Before first use
1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
After starting a programme, it may take up to 5 minutes
for the appliance to recharge the resin in the water
softener. It seems that the appliance is not working. The
washing phase starts only after this procedure is
completed. The procedure is repeated periodically.
The salt container
Caution! Use rough salt designed for
dishwashers only. Fine salt increases the
risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in daily
use.
Adding salt
Before the first use, put one litre of water in the salt container.
Caution! Water and salt can come out of the salt container during filling. To prevent corrosion, start a
programme immediately after filling the salt container.
22
