* The specifications of any product may change without prior notice to improve performance.
4
4. Apply Thermal Grease
Clean the contact surface of the VGA Chipset
completely. Apply thermal grease on the VGA
Chipset that makes contact with the
base of the FHS assembly.
5. Install the FHS Assembly
Align the FHS assembly’s base on the center
of the VGA Chipset. Screw each Bolt A on each
Nipple A slightly, and tighten each Bolt A a few turns
at a time, alternating between each bolt, until the
clip is completely attached to each Nipple A.
Notes)
Make sure that the heatsink's base
and the VGA Chipset are completely
in contact with each other.
RAM
Heatsink
Nipple A
VGA Chipset
Thermal
Grease
Bolt A
FHS
Assembly
Clip
Nipple A
VGA Chipset
3. Attach the VGA RAM Heatsinks
Remove the film from the thermal tapes on the
bottom of the RAM Heatsinks and attach the
heatsinks on the VGA RAM.
Note 1)
If thermal grease or other residue remains
on the RAM, the thermal tapes will not
stick. Clean the surface of the RAM with
acetone or alcohol before attaching.
Note 2)
The bonding strength of the thermal tapes
reaches 90% after 24 hours of curing.
Do not put excessive force on the RAM
heatsinks during this period.
Note 3)
Thermal tapes lose adhesiveness after it has
been used for attachment once and
cannot be reused. Purchase thermal
tapes separately should you try again.
RAM
Heatsink
VGA RAM
Thermal
Tape
Film
Nipple A
VGA Chipset
