ZCube-SC User Guide
DOC-USR-0265-01
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
48
Figure 48 Pinhole Reset
(1)
Allow the ZCube-SC to boot completely.
(2)
Press and hold pinhole reset switch until status light flashes yellow.
(3)
Power cycle device. Once the boot sequence has completed the ZCube-SC will return to its original
factory settings.
The ZCube-SC can also be reset via a USB device at boot:
(1)
Plug a FAT32 formatted USB drive into your PC.
(2)
To do a factory reset create a dire
ctory or file named “z3reset”. To only reset the password, create
a directory or file named “z3passreset” instead.
(3)
Eject the drive from your PC and plug into a powered down HE2K-DCK-1X. Power on the encoder.
(4)
When the boot is complete, the unit will be runn
ing the factory defaults if “z3reset” was used. If
“z3passreset” was used the unit will have the same settings except the password will be disabled.
9.0
DECODE OPTIONS
9.1
PC Configuration for HD HEVC/H.265 Decode
Due to the advanced processing needed to support HEVC/H.265 decoding at HD resolutions, a PC must
meet the following requirements:
▪
Nvidia GEForce GTX960 (desktop) or GTX960M (laptop) graphics card
