ZCube-SC User Guide
DOC-USR-0265-01
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
34
Figure 30 Setting NTP
6.8
Record to USB
The ZCube-SC supports writing encoded video to a storage device connected to the USB port in .ts file
format.
(1)
Connect a USB flash drive or other USB storage device to USB on the back of the camera, or insert a
microSD card into the slot on the side of the DCK.
Note:
The storage device must be formatted in either FAT32, VFAT, EXT3, or EXT4 format.
(2)
Return to the user interface, and if necessary, click on the
Stop
button in the
Channel Controls
section of the user interface CH1 tab or the
Stop All
button in the lower right corner of the screen of
any tab.
(3)
Verify the
Output Resolution
is set to
Follow Input
to output a HD stream. If a lower resolution
output is desired, select this in the dropdown menu and resizing will occur.
(4)
Select the
Video Codec
you would like to use for your video encoding.
(5)
Under Output Setup, select
TSFILE
from the
Output Format
dropdown menu.
Connect Storage
to USB 3.1 Port
Figure 31 USB Connection
