15
DOC-USR-0080-01
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
6.5
Streaming RTP
Once you have UDP streaming running, it is relatively simple to change to RTP streaming. All that is
needed is a change of settings and an SDP file (an example file is provided with the software release
from Z3). To stream using RTP, complete the following steps:
(17)
Click on “Stop Encoder” to stop the current encoding session.
(18)
Verify “Output Interface” is “Ethernet (VBR)”.
(19)
Change “Output Format” from “MPEG-2 TS” to “RTP”.
*Note:
Be sure not to select “MPEG-2 TS over RTP”.
(20)
Confirm that “Dest Port” is 8888- This will be important for the VLC configuration.
(21)
Click on “Start Encoder” to start the RTP encoding session.
Once you finish, your settings should match the following:
Figure 13 Changes to Encoding Parameters for RTP Encode
(2) Change Output
Interface to
“Ethernet(VBR)”
(3) Change Format to
“RTP”
(1) Click “Stop Encoder”
If encoder was running
(5) Click “Start
Encoder”
(4) Confirm “Dest Port”
is 8888
