18
Z3
C
on
fid
en
tia
l
DOC-USR-0269-08
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
11.3
Set up the Terminal Window
(1)
If you are running from a Windows PC, we recommend running TeraTerm for serial configuration and
monitoring. Select
“Setup –
Seri
al Port” and
use the following settings:
Port:
Whichever serial port the port is connected to
Baud Rate: 115200
Data:
8-bit
Parity:
None
Stop:
1-bit
Flow Control: None
(2)
If you are running from Linux, type:
# sudo minicom
–
s
And then configure by doing the following:
-
Select “Serial Port Setup”
-
Ensure the right Serial Device is specified (typically “/dev/ttyUSB0”)
-
Set option E (“Bps/Par/Bits”) to 115200 8N1
-Press <return>
-
Select “Exit”
11.4
Power on the Board
(1)
Connect the 12V 1A power supply.
(2)
Turn on the power switch. If all is configured properly, you will see the board booting up within the
terminal window. After 2 minutes, you will see the RPS Main Menu.
Note the local IP address and netmask (192.168.0.120 and 255.255.0.0 by default). This is the IP address
of the board. You will need this later to access the HTTP-based use interface.
