HETM-DCK-21 User Instructions
DOC-USR-0202-01
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
34
(4)
Enter an NTP server address. The default is 128.138.141.172 (NIST).
(5)
Click the change button. NTP is now enabled and your system clock will be adjusted.
Figure 29 Setting up NTP
6.8
Record to Micro SD
The HETM-DCK-21 supports writing encoded video to a storage device connected to the Micro SD port in
.ts file format.
Figure 30 Micro SD Connection
(1)
Connect a Micro SD card to the HETM-DCK-2x.
Note:
The Micro SD drive must be formatted in either FAT32, VFAT, EXT3, or EXT4 format.
(2)
Return to the user interface, and if necessary, click on the
Stop
button in the
Channel Controls
section of the user interface CH1 tab or the
Stop All
button in the lower right corner of the screen
of any tab.
(3)
Verify the
Output Resolution
is set to
Follow Input
to output a 4K stream. If a lower resolution
output is desired, select this in the dropdown menu and resizing will occur.
(4)
Select the
Video Codec
you would like to use for your video encoding.
(5)
Under Output Setup, select
TSFILE
from the
Output Format
dropdown menu.
Connect Storage
to Micro SD Port
