HE2K-DCK-1X User Instructions
DOC-USR-0122-05
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
53
8.8
Factory Reset
The Z3Cam-HD can be reset to its original factory settings using the pinhole reset on the lower right of
the rear interface panel of the unit.
Figure 55 Pinhole Reset
(1)
Allow the camera to boot completely.
(2)
Press and hold pinhole reset switch until status light flashes yellow
(3)
Power cycle camera. Once the boot sequence has completed the camera will return to its original
factory settings.
The HE2K-DCK-1X can also be reset via a USB device at boot:
(1)
Plug a FAT32 formatted USB drive into your PC.
(2)
To do a factory reset create a directory or file named “z3reset”. To only reset the password, create
a directory or file named “z3passreset” instead.
(3)
Eject the drive from your PC and plug into a powered down HE2K-DCK-1X. Power on the encoder.
(4)
When the boot is complete the unit will be running the factory defaults if “z3reset” was used. If
“z3passreset” was used the unit will have the same settings except the password will be disabled.
Figure 54 Password Entry Screen
