46
DOC-USR-0264-02
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
15.0
RUNNING THE CODE YOU BUILT ON THE BOARD
To take the image files you built in Section 9.0 and run them on the RPS, follow these instructions.
15.1
Via User Interface
(8)
Run the Web Interface (See Section 13.6 or 14.1).
(9)
Click the “Update device firmware”
button from the System Setup tab.
(10)
This brings you to the update image screen. In this screen, click on the
“
Choose File
”
button.
(11)
This brings you to the File Selection Screen. Navigate to the .img file to update with and
click “Open”.
(12)
Click on “Upload and Update”.
(13)
You will see screens stating that the image is being uploaded and that the flash is being
updated. After about one minute, you should see the main menu again.
(14)
Your encoder is now updated.
Figure 38 Updating the Device Firmware from the Web Interface
Figure 39 Updater Screen
Click Here
