FV4K-DCK-1X User Instructions
DOC-USR-0127-07
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
39
(10)
You can verify your recording by connecting the storage device to your PC and opening the newly
created .ts file in VLC media player.
Note:
The PC should be at least a quadcore or 8-core PC. If the PC is too slow, frame skips and possibly video
artifacts will be observed upon playback. VLC should be version 2.1.3 or newer.
6.9
Dual Steam and Record
Dual streaming and recording to .mp4 file simultaneously is supported in RTP, RTSP, UDP, TSRTP, RTMP, and
RTMPS modes. In UDP and TSRTP mode support recording to .ts file when low latency transport stream is
disabled (advanced setting).
(1) Go to CH1 tab and select RTP, RTSP, UDP, TSRTP, RTMP, or RTMPS as the output format.
(2) Set Aux File Enable to MP4File.
(3) Set Output Device and File Prefix as described in section 6.8 steps (7) and (8).
(4) Click start and repeat steps on the CH2 tab.
To activate the special case of stream and store to .ts file with UDP or TSRTP.
(1) Go to the System Setup tab and check the Advanced Settings checkbox. Click Save at the bottom of
the page.
(2) Go to the CH1 tab and select output format of UDP or TSRTP.
(3) Set
TS Lowlat Mode to False.
(4) Select TSFile form the Aux File Enable dropdown.
(5) Set Output Device and File Prefix as described in section 6.8 steps (7) and (8).
(6) Click start and repeat steps on the CH2 tab.
6.10
Microphone Input
(1)
Connect a microphone with a 3.5mm cable output to
MIC
on the back of the camera.
Connect
Microphone
to “MIC”
Figure 40 Microphone Connection
