FSDI2-DCK-1X User Instructions
DOC-USR-0233-01
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
35
Figure 31 Enabling KLV
6.7.1
Enable KLV Metadata Multiplex Mode via the RS232 Port
(1)
To receive KLV metadata via the RS232 port on the back panel of the DME-10. Set the Output Format
as UDP and set KLV Enable to True. Set KLV Mode to SERIAL and the KLV Serial Baud Rate to the rate
of the device feeding the KLV metadata. Our example assumes 9600 baud. To use the RS232 port
set int KLV Source to /dev/ttyAMA0. KLV has two multiplex modes and the DME-10 supports
both. Synchronous mode includes a timestamp in each TS packet while Asynchronous does
not. Choose based on the expectation of your decoder (many support both). The settings below
reflect those discussed above:
(3) Change to
“UDP”
(8) Click “Start”
(4) Select
“True”
(1) If necessary, click “Stop”
(2) Change to
“SDI”
(5) Verify settings
(6) Set to “SDI”
(7) Verify is “/dev/gv7601.0”
