DOC-USR-0272-01
FSDI-1XA User’s Guide
42
7.5.2
Camera Controller Software
(1)
Install your camera control software onto your PC.
(2)
Launch the controller software application.
(3)
Set the port name to match the
COM Port
selected previously.
(4)
Set the
Baud Rate
to
9600
.
(5)
Save these settings.
(6)
Remember, you may need to close and restart your camera controller application for changes to take
effect.
If you do not have camera control software it is possible to write your own. An example application
for sending VISCA commands from a Windows PC to the FSDI-1XA has been provided in APPENDIX C:
Example Camera Controller Application.
Figure 49 Com2TCP Configuration
Set to “1000”
Set to the IP
Address of
Your Z3 Unit
Set to
“9600kbps”
Match Values
Com2TCP
Camera Control Software
Figure 50 Camera Controller Software Configuration
