28
DOC-USR-0264-05
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
13.6
Access the User Interface
The following actions can be completed in either the serial interface or an HTTP-based user interface
run on a web browser. For ease of use, the HTTP-based interface is described.
(1)
Open an Internet browser window on your PC (for best results, FireFox or Chrome are recommended)
and enter the IP address of the RPS (192.168.0.120 by default) into the URL text box. The HTTP-
based graphical user interface (GUI) appears at the CH1 tab. (See Section 14.1 for information on
accessing the user interface using the ZFinder PC utility.)
13.7
Configure Channel 1 for Streaming UDP
Note:
Settings in the user interface cannot be changed if the unit is currently encoding.
(1)
If necessary, click on the “
Stop
” button in the “
Channel Controls
” section of the user
interface CH1
tab or the “
Stop All
” button in the lower right corner of the screen of any tab.
(2)
In the CH1 tab,
verify the “Video Source” is set to “HDMI” using the dropdown menu.
(3)
Change “
Output
Resolution” to “1920x1080” or “Follow Input”.
(4)
Select the codec you would like to use for your encoding. Both H.265/HEVC and H.264/AVC are
supported. In the pictured example, verify “Video Codec” is set to “H265(HEVC)”.
(5)
S
et “Output Format” to “UDP”.
(6)
You ca
n set “Dest Address” to:
(a)
the IP address of your PC that will be running VLC media player (in the pictured example,
192.168.0.6).
(b)
or to a multicast address (An example multicast address would be “225.1.2.3”. If you are
on a shared network, check with your Network Administrator.)
(7)
Also make note of the value of “Dest Port” (
8600 by default).
Note:
By default a limited selection of video encoding settings are available in the user interface. See Section
”, for more information on accessing additional settings.
(8)
Click
the “Start” button
.
