26
DOC-USR-0264-05
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
(4)
Connect an Ethernet cable to the board and a switch or router on the same network as your PC or
directly to your PC.
13.2.1 Encoding HEVC Interlaced Streams
The FVXK/FSDI-13A-RPS can encode interlaced streams with H.265 (HEVC)
(1)
Check
Advanced settings
on the
System Setup
tab.
(2)
On the Channel tab you want interlaced support on, select
Separated
from the
Video
Interlaced Mode
drop down list.
Currently ffplay is the only PC player capable of playing the H.265 interlaced stream properly.
Using the following command:
ffplay -vf tinterlace=merge rtsp://
<IP ADDRESS OF Z3 DEVICE>
/z3-1.mp4
Within the command the -vf tinterlace=merge option is what tells ffplay what to do with the
interlaced fields. You may also use Z3 H.265 Decoder products to play back the H.265 interlaced
streams. The interlaced stream will be detected automatically.
13.3
Set up the Terminal Window
(1)
If you are running from a Windows PC, we recommend running TeraTerm for serial configuration and
monitoring. Select
“Setup –
Serial Port” and
use the following settings:
Port:
Whichever serial port the port is connected to
Baud Rate: 115200
Data:
8-bit
Parity:
None
Stop:
1-bit
Flow Control: None
(2)
If you are running from Linux, type:
# sudo minicom
–
s
And then configure by doing the following:
-
Select “Serial Port Setup”
-Ensure the right Serial Device is specified (typically
“/dev/ttyUSB0”)
-
Set option E (“Bps/Par/Bits”) to 115200 8N1
-Press <return>
-
Select “Exit”
13.4
Power on the Board
(1)
Connect the 12V 1A power supply.
(2)
Turn on the power switch. If all is configured properly, you will see the board booting up within the
terminal window. After 20-30 seconds, you will see the RPS Main Menu.
