Z-Wave Alliance CT200-G1, User Manual

Page: 27 / 34

CT200-G1 User Guide
Table 6: Configuration Value Value
Name 0000 0001 0010 0011 0100 0101
Cooling Type None AirCon Heat-
Pump Evapora-
tive n/a n/a
Heating Type None ForcedAir Heat-
Pump
Radiator n/a n/a
Heating Fuel n/a Gas Electric Oil Geother-
mal Propane
Heat/Aux Stages n/a 1 2 n/a n/a
A Terminal n/a Humidify Dehumid-
ify EX W3 n/a
Heat Pump
Stages
None 1 2 n/a n/a
O/B Terminal n/a O B n/a n/a
Cooling Stages None 1 2 n/a n/a
Utility Lock
The Utility Lock parameter enables or disables the utility lock. If the utility lock is enabled, the
thermostat setpoint cannot be modified by the user on the thermostat physical user interface.
Table 7: Utility Lock
Name Value
Parameter (8-bit) 0x03
Size (3-bit) 0x01
Configuration Values (8-bit) Lock State
Configuration values are bit-encoded. Unsupported values will be ignored.
Table 8: Lock State
Value Configuration
0x00 Disabled lock (DEFAULT)
0x01 n/a
0x02 n/a
0x03 Enabled lock
Thermostat Power Source (Get Only)
The Thermostat Power Source parameter is a read-only status of the thermostat power
source. The Power Source is either C-Wire or batteries. C-Wire is the power source if both
C-Wire and batteries are present. The power source is fixed when the thermostat joins the
Z-Wave network.
Table 9: Power Source
Name Value
Parameter (8-bit) 0x04
Size (3-bit) 0x01
Configuration Values (8-bit) Source
Configuration values are bit-encoded.
23