Z-Wave Alliance CT200-G1, User Manual

Page: 22 / 34

CT200-G1 User Guide
Thermostat Warnings
Compressor Protection Warning indicates compressor protection is active.
The Home screen shows an hour glass and the message “Please Wait”. The Thermostat has a mini-
mum cycle time of four (4) minutes to protect your compressor from excessive wear from responding
to thermostat changes. The compressor will restart after the four-minute delay.
Low Battery Warning indicates battery voltage is low.
The Thermostat displays this screen when the batteries are running low on charge and should be
replaced. This screen will only display once per day the first time the screen wakes.
Dismiss Warning Press the side button.
Eliminate Warning Replace the batteries.
1. Turn the thermostat mode to OFF (from heat or cool).
2. Remove Thermostat from mounting plate.
3. Replace the batteries.
4. Replace Thermostat to mounting plate.
5. Adjust the thermostat mode as desired.
Your settings will be retained and the thermostat will automatically reconnect to the Z-
Wave Network
Network Disconnected Warning indicates the thermostat has lost the connection to the Z-Wave network.
This screen will only display once per day the first time the screen wakes.
Dismiss Warning Press the SIDE button.
Connect Network Navigate to the Menu Screen > Configure > Network, and follow the
procedure to include the Thermostat to the Z-Wave network.
Firmware Updating Warning indicates an active firmware upgrade.
Wait until the firmware update is complete before attempting to use the Thermostat.
18 Chapter 2. Operation Guide