Z-Wave Alliance CT200-G1, User Manual

Page: 19 / 34

CHAPTER
2
Operation Guide
Product Overview
Home Screen is the default screen on the Thermostat.
Anytime the unit wakes from sleep, the screen lights up and displays the system’s mode (top), the
target temperature (center), and the current room temperature (bottom). Wait 10 seconds for the
device to sleep, then press any button to wake it again.
When in Heat mode, the light bar at the bottom of the Thermostat glows red. When in Cool mode, it
glows blue. When the unit is off, the light bar does not glow. When the system is actively heating or
cooling, the colored glow flickers.
Adjust Temperature Press +/- to change the target temperature.
Change Thermostat Mode Press the side button once, then Press +/- to select mode.
Fan Screen enables you to change fan operation and set the fan timer.
View Screen Press the SIDE button twice.
Outside Weather Screen displays the outside temperature and outside humidity.
View Screen Press and Hold the side button until screen appears, then release.
Change Screen Press +/- to toggle between temperature and humidity.
Menu Screen enables you to adjust the Thermostat settings, view information about the Thermostat, and
configure the Thermostat.
View Screen Press and Hold the side button for 5 seconds.
Navigate Screen Press +/- buttons to move the cursor on the screen.
Select Item Press the side button to make a selection.
Go Back Navigate to “Back” and press side button.
15