Detach Positioning holder and fix
Parallel sliding holder by a screw.
Thank you for your purchase of Saw Guide Mini.
Please read this instruction carefully and keep it in good condition.
Caution :
Do not drop the guide and the saw as damage to them may occur.
Do not over tighten screws, as it may cause damage to screws, nuts or the guide.
Saw Guide Mini can not be used with double saws or saws which has the blade thicker than 0.5mm.
Always use Saw Guide Mini with Z-Saw UNIVERSAL S-175 or its spare blades.
Do mot use this product for a purpose for which it was not intended.
Notice :
Specifications may change without notice to improve quality.
Copyright
2003 Okada Hardware Manufacturing Company Limited. All rights reserved.
Wide board
Mark the position where you want
to cut.
Insert Dummy plate into the gap between
Guide base and Guide plate, and adjust
the position of the Guide and Slide bar to
the mark of the lumber. Fix Slide bar to the
board with clamps.
Prepare a straight edge or a straight
wooden piece to be used as Slide bar.
①
Guide base
②
Guide plate
⑩
Dummy plate
⑨
Parallel sliding
holder
Clamp
ＭＥ２００４１２０Ａ
Slide bar
⑥
Screws
Saw guide gauge
Fix the angle with the center screw.
④
Nut plate for Guide plate
⑥
Screws
（
Size: M4
）
①
Guide base
（
aluminum
）
⑤
Positioning holder
（
aluminum
）
for cutting square lumber
③
Spacing plate
（
0.53mm thick
）
⑥
Screws
（
Size: M4
）
②
Guide plate
Contents and parts name
Before using Saw Guide Mini
Applications : Cross, Rip and Slant-cut, general wood, hardwood, composite wood, plywood
Specifications : Blade thickness: 0.5mm, tooth pitch 1.40mm, kerf 0.66mm, Blade Length 180mm
１８０ｍｍ
PISTOL S-117 Green
Instruction Sheet
⑩
Dummy plate
⑨
Parallel sliding holder
（
aluminum
）
⑦４５°
angle attachment
（
aluminum
）
⑧
Screws
（
Size: M4
）
⑨
Parallel sliding holder
Replace Dummy plate with Z-Saw UNIVERSAL
S-175, then start sawing by moving the guide
backward.
How to use Saw Guide Mini #4
Saw Guide Mini optional parts
Refer to “How to use Saw Guide Mini #3,#4”
Refer to “How to use Saw Guide Mini #4”
Refer to “How to use Saw Guide Mini #2”
Z-Saw UNIVERSAL S-175
(is designed to be used with Saw Guide Mini)
This is a protractor for checking angles or marking.
Okada Hardware Mfg.Co.,Ltd.
561 Omura, Miki-shi, Hyogo, Japan 673-0404
TEL: 81-794-83-1111 / FAX: 81-794-83-5111
URL: http://www.z-saw.co.uk E-mail: [email protected]
