Saw Guide, Free Angle
Instruction Sheet
(How to Use)
TFE200508A
45°
90°
※
KNOB
T-SHAPE HEX WRENCH
Saw Guide Free Angle
※
POSITIONING HOLDER
… for cutting square lumber
※
marked parts are packed in a
Vinyl envelope
.
SPARE SCREW
SPARE WASHER
DUMMY BLADE
Teeth edges should always stay
out of the saw guide plates.
Teeth edges touch inside
of saw guide plates.
These are actually made by using Z
‐
SAW UNIVERSAL S-265
& Saw Guide, Free Angle.
THIS SAW IS SPECIALLY DESIGNED AND PRODUCED TO BE USED WITH
SAW GUIDE-FREE ANGLE
AND SAW GUIDE .
ADVANTAGES OF
Z-SAW UNIVERSAL S-265
●
HIGH QUALITY SAW BLADE IS DURABLE, FLEXIBLE AND RUST RESISTANT.
●
SPECIAL CUTTING EDGE DESIGNED FOR RIP, CROSS & SLANT CUTS.
●
EASY & QUICK BLADE REPLACEMENT STYLE (Convenient for tool box storage).
●
NON-SLIP ELASTOMER COVERED GRIP HANDLE.
Cutting on the pull-stroke
prevents blade from buckling
and binding, allows blade to
be thin. The thinner blade
removes less material, makes
sawing easier, faster and
more accurate!
45°
45°
45°
90°
Features:
This innovative Adjustable angle saw guide is designed for the exclusive use by Z
‐
SAW universal s-265.
Quick and very easy angle adjustment for sawing at any angle between both 45
°
right & left direction as well
as both 45
°
front & back inclined direction. Rigidly and precisely constructed steel-made Adjustable angle
saw guide ensures accurate straight cuts, and it can be held in a position firmly by hand supporting with
positioning holders. Equally suited for left and right hand position. Long straight cut on a wide board is also
easily possible by using the parallel sliding holder. Special Saw Guide Gauge and Dummy
Ｂｌａｄｅ
for exact
angle adjustment are available.
Oh, did you make these?
Vertical angle bracket
Spacing
plate
Guide plate
fixing screw
Height
adjusting
knob
Base plate
Vertical angle fixing screw
Guide Plate
Height adjusting nut
Construction of Parts
※
PARALLEL SLIDING HOLDER
… for cutting wide board
CUTS ON
THE PULL
STROKE
Horizontal angle
adjusting screw
Rotating base part of angle bracket is
pre-set at factory. Do not loosen
the screw.
Okada Hardware Mfg.Co.,Ltd.
561 Omura, Miki-shi, Hyogo, Japan 673-0404
TEL: 81-794-83-1111 / FAX: 81-794-83-5111
URL: http://www.z-saw.co.jp/en E-mail: [email protected]
M o d e l : 2 6 5
Type Medium-Fine
Overall Length 420mm(16-
½”)
Blade Length 265mm(10-
½”)
Blade Thickness 0.60mm(0.024
”)
Kerf 0.92mm(0.037
”)
Pitch 14TPI
Thank you for your purchase of Saw Guide Free Angle.
Please read this instruction carefully and keep it in good condition.
Caution
○
Do not tighten screw too strong. It may damage hex screw or T-shape
hex wrench.
○
Teeth should always stay out of the saw guide plate.
Otherwise teeth edge will be damaged by insides of saw guide plate.
See pictures right
→
○
Do not tighten the knob too strong. It may be damaged.
○
Wear safety goggles.
Notice
○
Specification may change without notice to improve quality.
○
The copyright belongs to Okada Hardware Manufacturing Company Limited.
SAW GUIDE GAUGE
…for angle adjustment
Put the saw blade into
handle deep enough to
cover the end slit of the
blade.
