9
• Set LED Headlights
“
LED CMHSL
” configure
vehicle for the LED third brake light
• Set LED Fogs
“
LED FOGS
” configure vehicle for
LED fog lights
• Set LED Tails
“
LED Tails
” configure vehicle for LED
tail lights
(aftermarket lights may require a resistor harness)
• Taillight Type
“
Tail
” configure taillights for
overseas conversion
(If you are unable to restore the
default value, you should Unmarry as described on
page 6 to return to stock.)
• Set LED Front Turn
“
LED FTrn
” configure
vehicle for LED front turn signals
NOTE:
For this setting, after the required
Full Reboot and
two sleep cycles
, run each blinker for
20 seconds each
.
If this does not clear hyperflash and you have
aftermarket
lights
, your lights
might require a resistor harness
.
• Set Trailer Tow
“
TRLR Tow
”
:
Configure the
vehicle for MOPAR trailer towing wiring kit
Offroad Submenu “Offroad”:
offroad-related options
• Set EPSteer
“
EPSteer
”
:
This setting is used if
you deleted the factory electronic steering pump for a
hydraulic pump.
• Set LOCKER
“
Locker
”
:
This setting is used if you
deleted the factory axle lockers. You can delete front
only, or both.
• Set Power Mirrors
“
PwrFold
”
:
This setting
activates newly-added MOPAR power folding mirrors.
• Set MIrror Turns
“
MirTurn
”
:
This setting
activates newly-added side-mirror turn signals.
• Set Mirror Tow
“
MirTow
”
:
This setting activates
newly-added mirror lights.
• Set Mirror Approach
“
MirApr
”
:
This setting
activates newly-added approach mirror lights.
Mirror Submenu “Mirror”:
mirror options
Other Submenu “Other”:
additional vehicle settings
• Set AUX
“
AUX
”
:
Set to YES, this configures the
vehicle for the AUX button package.
• Set Blind Spot
“
BlindSpot
”
:
Set to YES, this
configures the vehicle for the AUX button package.
• Side Step
“
PwrStep
”
:
This setting will activate
the MOPAR side step (Mopar Deployabe Step Kit
82215287AD) after installation.
• Trailer Brake
“
TrlrBrk
”
:
This setting will activate a
MOPAR trailer brake controller.
• Set Seatbelt Ding
“
BeltDing
”
1
:
Set to OFF,
this will disable the chime when your seatbelt is off. The
seat belt warnings on the dash will continue to function.
(EXPERIMENTAL)
Always wear your seatbelt.
• Set Splash
“
Splash
”
:
With this setting you can
choose the cluster splash screen.
There are many
choices but not all will work, and some may set an error.
TRX can only use the TRX splash.
• Set Panic
“
PanicBtn
”
:
Set to NO, this disables the
PANIC button on the keyfob.
• SGW Lock
“
SGW
”
:
Set to NO, this allows access
through the security gateway for dealer tools.
Use
this feature only if you know your dealer doesn’t mind
aftermarket mods.
Otherwise, you should Unmarry and
remove the Tazer before dealer service.
