YZ Systems NJEX 7300L, Instructions & Operating Manual, Page: 68 / 126

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
Page 58
NJEX 7300L ver.09042003
SSSSS
ECTION ECTION ECTION ECTION ECTION
9: S 9: S
9: S 9: S
9: S
ETTING ETTING ETTING ETTING ETTING
& T & T
& T & T
& T
ESTING ESTING ESTING ESTING ESTING
A A
A A
A
LARMS LARMS LARMS LARMS LARMS
Setting The Clock
The internal clock in the N-300 should be maintained
to reflect the current local time and date. When a
system is first placed into service the clock should be
set for local time and date. This clock is a 24 hour,
military time, clock and therefore the hour of the day
will be set between 00:00 and 23:59. It is important
that this time and date be correct as data logged will
be reflected from this clock setting. If daylight savings
time, or other similar hour-shift adjustment, is ob-
served, these changes should be made manually to
the clock as they occur. Any change to the clock will
be logged in the Sentry4 data file.
Choose *Set in the main menu, figure 193.
Choose *Cal in the set selection menu, figure 194.
Choose *Clk in the calibration selection menu, figure 195.
To set the Clock, figure 196, press and release the
Select key. First, the numerical value for the Month will
begin flashing when chosen. Use the Up Arrow key to
increase the value and the Down Arrow key to de-
crease the value. When a new value has been chosen,
press the Enter key to store the new Month into
memory. The entered value will stop flashing when it has
been loaded into memory, then the numerical Day of the
month value will begin to flash. Use the Up Arrow key
to increase the value and the Down Arrow key to
decrease the value. When a new Day value has been
chosen, press the Enter key to store the new Day into
memory and the Day of The Week will begin to flash.
Use the Up Arrow key to increase the value and the
Down Arrow key to decrease the value. When a new
Day of the Week has been chosen, press the Enter key
to store the new Day of the Week into memory. Now
the Year value will begin to flash. Use the Up Arrow key
to increase the value and the Down Arrow key to
decrease the value. When a new Year has been
chosen, press the Enter key to store the new Year into
memory. The last two settings will be for the Hour of the
day and the minutes after the Hour. The Hour value
will begin to flash. Use the Up Arrow key to increase
the value and the Down Arrow key to decrease the
Figure 193
pmp bat vmtr sig tnk
PropFlow Idle
*Strt *Dsp *Set
pmp bat vmtr sig tnk
Set Selection
*Par *Cal *Esc
Figure 194
pmp bat vmtr sig tnk
Calibration Set
*Clk *Inputs *Esc
pmp bat vmtr sig tnk
Set Date and Time
12:07 07-12-Thu-2001
Figure 195
Figure 196