YZ Systems NJEX 7300L, Instructions & Operating Manual, Page: 17 / 126

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
Page 7 NJEX 7300L ver.10012003
SSSSS
ECTION ECTION ECTION ECTION ECTION
2: 2:
2: 2:
2: S S
S S
S
Y YY Y YSTEM STEM STEM STEM STEM
I I I
I
I
NST NST NST NST NSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
Standard System Mounting
Figure 5
1. Bolt down the system enclosure to a concrete slab
using the mounting holes (9/16") provided in the
bottom of each leg of the enclosure. Recommended
bolt/stud sizes for mounting the enclosure is 1/2".
2. Connect a ground wire from the grounding lug located
on the enclosure leg to a properly installed ground rod,
located adjacent to the system enclosure.
* Resitance to ground must be less than 1 Ohm.
'A'
8-10 AWG
Grounding Rod
Depth of
4'-0" Min.
FRONT VIEW SIDE VIEW
BACK VIEW
'B'
TABLE 1
SINGLE
DUAL 40 1/4"
20 3/4"
A
'C'
39 1/2"
20 1/4"
B C
9"
9"