Yukon LWO-112, Owner'S Manual

Page: 10 / 68

Furnace Features - Eagle II - Polar
YUKONTROL DS-103 SOLID-STATE
FURNACE CONTROL
This is the solid-state
control that coordinates the gas or oil burner
function with the wood/coal damper so that your
home is always comfortable using your choice of
fuels.
MORE HEAT EXCHANGE SURFACE
MEANS LESS HEAT UP THE CHIMNEY
The 8-inch diameter type 304 Stainless Steel
secondary heat exchanger recovers heat that would
normally go out the chimney. This added surface
plus the large firebox and massive primary heat
exchanger provide a total of 82 square feet of
heating surface compared to 30-35 square feet on a
comparable size oil or gas furnace.
GAS BURNER OPTION FOR AUXILIARY
FUEL
Our gas model comes with a Wayne Model
P250 AF DIN hi-efficiency gas burner. This burner
features a Honeywell electronic ignition and gas
valve. It is certified by Underwriters Laboratories to
provide up to 80.1% steady state efficiency. It can
be switched from LP Gas to Natural Gas or visa-
versa. This burner can be interchanged with our
Wayne model MSR oil burner at your option.
2 DIFFERENT STYLES OF HEAVY CAST
IRON GRATES
It is imperative that 80 percent
of the air for combustion enters the firebox from
below a wood/coal grate to insure an efficient and
clean burning fire. Our standard heavy cast iron
grate is adequate for a wood fire. A much heavier
cast iron shaker grate is also available as an option
for dense coal use.
A SEPARATE OIL OR GAS FIRE
CHAMBER ENGINEERED FOR THOSE
FUELS
This is an important feature.
The chamber is lined with PYROLITE TM , an extremely
high temperature resistant ceramic material. It assures
efficient combustion of oil or gas, and directs those
flames into the wood burning chamber for automatic
ignition of the wood fire.
FIRE BRICK LINING EXTENDS
FURNACE LIFE
Every Eagle furnace features
two inch thick fire brick, 18" high. Fire brick is used,
not only because of its lasting quality, but because it
also retains heat for better efficiency.
AFTER-BURNER TM JET SYSTEM GIVES
MAXIMUM SOLID FUEL BURNING
EFFICIENCY
It extracts maximum BTUs from
the wood or coal. Superheated air is introduced
above the fire to ignite and extract heat from the
unburned combustible gases. Without this feature,
up to 40% of the available solid-fuel energy would
be wasted.
OIL BURNER OPTION FOR AUXILIARY
FUEL
If oil is your preference for a back-up fuel,
your burner will be a Wayne model MSR 321-009
hi-efficiency oil burner. Features are a Stainless
Steel flame retention head and Honeywell Premium
controls. It is certified by Underwriters Laboratories
to provide up to 80.1 % steady state efficiency. If at
some time in the future, you decide you would
rather have LP or Natural Gas as your backup fuel,
this burner can be interchanged with our Wayne
P250 AF DIN gas burner. (A nice insurance policy.)
AIR CIRCULATING BLOWER AND
MOTOR
The EAGLE II is designed with 10 inch
wide, ten inch- diameter belt drive blower. This
oversized blower turns slower than ordinary
furnaces because of its large size. It is therefore
quieter than most furnaces, Each EAGLE II is
equipped with a premium Class A motor with Class
B insulation, which means it will operate in a higher
temperature atmosphere. This motor also features
a 1.35 service factor, which means it has 35% more
power than a standard motor of the same size. Up
to 5 tons (60,000 BTU’s) of air conditioning can be
added to an EAGLE II.
10
Furnace Features - Eagle II- Polar