•
Do not direct a unit in the “on” position at intense sources of light, such as car's headlights or
burning fire. This may disable the unit for an unknown length of time or cause a dark spot in
the center of the field of view. Do not turn the unit on in daylight without the protective cap
firmly secured over the objective lens, as this may damage the unit.
•
Any such damage may void the warranty.
•
Never leave the unit in the “on” position over an extended length of time in an area with a light
level exceeding 1-10 lux (twilight - 10lux, deep twilight - 1 lux). Please keep the protective cap
on the objective under greater light level.
•
Your Exelon was designed to be self-contained. Do not open the body of the scope or
otherwise attempt to service this device. If such need arises return the unit for replacement or
repair.
•
Protect the device from exposure to direct sunlight and extreme temperatures.
•
Avoid dropping or otherwise shocking the unit. The device incorporates a sophisticated optical
system which could be damaged in extreme cases of misuse.
•
Clean optical parts (lenses) with professional lens cleaning supplies designed for use with
multicoated optics.
Damage to this device from failure to observe these warnings may void the device's warranty!
BATTERY INSTALLATION
Your Exelon runs on 1 CR123A battery. To install, unscrew the battery compartment cover, insert the
battery into the battery compartment so that the positive (+) and negative (-) terminals of the battery
match the markings inside the compartment, replace the battery cover carefully.
Do not overtighten.
USE AND TESTING
Make sure that the battery has been installed according to instructions found in the battery installation
section of this manual.
•
Enter a dark area before turning on the device.
•
Remove the objective cap (1) and fix it on the left side of the housing.
•
Activate the device by pushing the “ON” button (3).
•
You can test your device in a light area without removing the protective cap. This will not
damage your unit.
•
If the subject to be viewed is in a completely dark area, including lowlight shadow areas;
activate the infrared illuminator by pressing the “IR” button (2) located next to "ON" button.
•
Direct your Exelon at an object at a distance of approximately 100m. Adjust the eyepiece and
objective lens diopter setting to focus the unit by rotating the eyepiece (4) and objective lens (5).
•
After the adjustment, do not rotate the eyepiece irrespective of the distance and other
conditions.
