Thank you for using an EXO™ Sonde
for your environmental monitoring!
This document will assist with the initial steps
required to use an
EXO Sonde
.
Refer to the EXO User Manual for:
•
Part numbers and accessories
• Maintenance guidelines
• Sensor calibration instructions
• Connecting EXO to a Data Logger
See reverse for more information.
Install probes into the sonde bulkhead
Items Needed
Included in Packaging
• EXO Sonde
• Batteries*
• Battery cover wrench*
• Sensor tool with magnet
(to activate
Bluetooth®
)
• Kor™ Software on USB flash drive
*Applies to EXO Sondes with a battery
compartment only.
Not Included
• Sensors (Probes)
• EXO Handheld or PC running Kor Software
• USB cable and adapter, field cable,
or EXO GO (sold separately)
Preparing Sonde for Use
To prepare the sonde for operation,
you will need to:
• Install probes into the connector ports
on the sonde bulkhead
• Install batteries
• Load Kor Software and drivers onto PC
• Connect sonde to EXO Handheld
device or PC
Install Sensors
1. Remove buffer bottles and hydration caps
on the sensors (if applicable).
2. Remove the calibration cup and guard
from the sonde.
3. Remove port plugs and install the sensor onto
the bulkhead. Start by finger-tightening each
locking ring until snug. Then use the probe
tool to give the locking ring another quarter
turn until it is fully seated on the bulkhead. Be
careful not to over-tighten or strip the port.
Ports are “universal,’” which means any sensor**
can be plugged into any port.
The Central Wiper must be installed in the
correct port to function properly:
• EXO2
– Port 7
•
EXO3
– Port 5
** EXO NitraLED may only be installed on:
• EXO2
– Port 6
•
EXO3
– Port 4
Registration
Register your product online to
activate your warranty and keep informed
of software updates:
YSI.com/warranty
Keep your serial number on file:
Date of purchase:
Unpacking and Inspection
Inspect the outside of the shipping container(s)
for damage. If you see any damage, contact the
shipping carrier immediately.
Remove the equipment from the shipping box.
Some parts are loose in the box, so check the
packing material carefully.
Quick Start Guide
Item #603794
Item# 603794 Dwg# 603794
April 2021 Rev D
EXO3
S
EXO3
EXO2
S
EXO2
EXO1
S
EXO1
