YSI 5200A
33
YSI 5200A
32
Figure 3.7
5. Fasten the mounting brackets to the back of the 5200A enclosure with the
mounting screws - figure 3.2, page 28.
6. Tighten the screws, securing the brackets to the 5200A.
7. Drill a hole in the panel for 5200A enclosure (dimensions provided with
kit).
8. Place standoffs between 5200A mounting brackets and panel surface -
figure 3.8.
9. Secure 5200A to panel with frame using washers and bolts provided.
Figure 3.8
Installation and Wiring
10. Reattach lanyard by placing lanyard at proper location of display board
panel. Make sure lanyard is fully seated on display panel boss to ensure
proper clearance when front panel is closed - figure 3.7.
11. Replace four screws to reattach display board panel to front panel enclo-
sure - figure 3.6.
12. Connect 5200A display board to ribbon cable -figure 3.5.
13. Secure the 5200A front panel to the frame using mounting screws. Follow
procedures provided at
Close Front Panel
- page 40 to secure 5200A and
protect internal electronics.
14. Tighten the screws, securing the 5200A to the panel.
Install the Weather Shield
Install the weather shield for outdoor installations. The weather shield can be used
with either a surface or a rail mount. The weather shield kit (model number 6505)
includes a weather shield, u-bolts, pre-drilled metal plate, washers, and nuts.
1. First complete steps 1-2 under Surface Mount or steps 1-3 under Rail
Mount depending on the type of installation. Note: You may need to
modify the pre-drilled holes in the weather shield depending on the
mounting location.
2. At step 3 (surface mount) or step 4 (rail mount), attach the weather shield
to the surface or rail with the metal plate installed to secure the weather
shield to the surface or rail. Figure 3.9 shows the weather shield installed
for a rail mounted 5200A.
3. Tighten the screws, securing the weather shield.
Figure 3.9
Installation and Wiring
