INSTRUCTION SHEET
811F658-TAB/BASE
Dining Table
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts
that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
Qty.
# Description
Qty.
A
Table Top
1pc
B
Mounting Plate
1pc
C
Center Post
1pc
D
Side Post
2pcs
E
Base
1pc
F
Hardware Pack
1bag
Assembly Procedure
: (Please follow the sketches below.)
Step 1:
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2:
Put all parts on a soft and smooth surface to avoid damage or being scratched. Detach
mounting plate (B) off table top (A) using wrench (1), keep the bolts, spring washers and flat
washers for step 4.
Step 3:
Attach the center post (C) to the side posts (B), and then connect the base (E) to the posts (B)
with phillip head bolts (3), spring washers (4) and flat washers (5) using wrench (1).
Step 4:
Attach the posts (C & D) to mounting plate (B) with phillip head bolts (2), spring washers (4),
and flat washers (5) using wrench (1) from hardware pack (E). And then attach mounting
plate (B) to table top (A) with the bolts, spring washers and flat washers from step 2. Tighten
all the bolts and turn the table upright.
Assembly is now complete.
Ready to show your home some love? Be sure to check all packing material carefully for small parts that may
have come loose inside the carton during shipment.
YOUNG HOUSE LOVE
From the makers of Universal Furniture
Round Trestle Table
