YO People Counter
User guide
v1.0
page 27/35
Sub-band 5; 921.6 - 923.0 MHz; channels 32-39
5
Sub-band 6; 923.2 - 924.6MHz; channels 40-47
6
Sub-band 7; 924.8 - 926.2 MHz; channels 48-55
7
Sub-band 8; 926.4 - 927.8 MHz; channels 56-63
8
AS923
Sub-band 1; 922.0 -923.2 MHz; channels 0-8
1
Not
supported
R/W
Sub-band 2; 923.2 - 924.5 MHz; channels 9-17
2
Configuration node
Connect to the device following these instructions:
1. Go to
and log in.
2. You’ll see the dashboard organisation view. Now go to the Application section in the sidebar.
3. After choosing your application, search for and select the device by looking at the DEV EUI
on the device sticker, which matches the NODE ID on the list.
4. Select the firmware section. Now you can see three different buttons:
●
Configure - here, you can change and upload the device parameters.
●
Update firmware – here, you can update the firmware to version 3.4.0 and newer.
●
Recover device - this section recovers the firmware of the device. This button helps if
you lose connection while uploading firmware.
5. After selecting the configure button and connecting the node, the next step is to configure
the parameters. Now you can change them in the section ‘device‘ or ‘detectionarea’.
REV 1.0
