YO Analog
User guide
v2.0
page 9/15
Quick start guide
Required equipment/software:
●
PC with Bluetooth adapter (USB dongle or built-in),
●
power supply 6 - 30 V DC, 5 - 21 V AC,
●
Yosensi CLI tool.
NOTE
Yosensi CLI tool works only with YO Analog default Yosensi firmware.
For official firmware updates, contact us on [email protected].
Node configuration
Connect to the device following these instructions:
1. Read the macBLE address from the sticker on the device. Alternatively, you can identify
the device by RSSI parameter (which correlates with distance between transmitter and
receiver).
Figure 5
Device information sticker/nameplate example.
2. Make sure you have your Bluetooth LE adapter turned on and working properly.
3. Download and run the CLI tool in the terminal/console application.
4. Connect power supply pins (regardless of polarity) of the YO Analog device. See Quick
Installation Guide for step by step instructions.
5. Run
yosensi-cli-tool_vX.X.X_WIN.exe list
to scan for Bluetooth devices. You can
see all commands by typing
yosensi-cli-tool_vX.X.X_WIN.exe --help
or add
-h
to
your current command to see all needed parameters.
6. If you find your MAC address in the
list
command results, you can connect and
reconfigure the device by using one of the available commands. You should use
change_dev_params
subcommand to change device settings. Additional information,
including the commands supported by the CLI, are available at
.
REV 2.0.0
Summary of Contents for YO Analog
Page 1: ...YO Analog User guide v2 0...
