York YD Mod D, Operation Manual, Page: 86 / 160

Harmonic filter details screen
Figure 32: Harmonic filter details screen
This screen displays more detailed information about the optional IEEE-519 Harmonic Filter. There
are two separate screens. One for each filter but the information is similar.
Table 76: Display only fields
Field/LED name Description
Motor run (LED)
Indicates whether the digital output from the controls is commanding the motor to
RUN.
% Full Load Amps
Displays the motor current as a percentage of the Full Load Amps (FLA) value. For the
Variable Speed Drive this is the data returned by the VSD Logic Board.
Motor current limit setpoint
Displays the current limit value in use. This value could come from a 0 mA to 20 mA, 4
mA to 20 mA, 0 VDC to 10 VDC, or 2 VDC to 10 VDC input in Analog Remote mode, PWM
signal in Digital Remote mode, SC-EQ communications interface in ISN (BAS) mode, or
a locally programmed value.
VSD model Displays the VSD model as reported by the VSD logic board.
Operating mode (run/stop) Indicates whether the Harmonic Filter is operating or not.
Phase rotation Displays the phase rotation detected by the Harmonic Filter (A, B, C or C, B, A).
DC bus voltage Displays the DC Bus voltage as measured by the Harmonic Filter.
Total supply kVA Displays the total supply kilovolt-amperes measured by the Harmonic Filter.
Heatsink temperature Displays the temperature of the Harmonic Heatsink (baseplate).
Voltage peak (N-L1, N-L2, N-L3)
Displays the 3-phase peak voltages as measured by the Harmonic Filter (Neutral to
Line).
RMS voltage (L1-L2, L2-L3, L3-L1) Displays the 3-phase RMS voltages across each line.
Voltage total harmonic distortion
(L1, L2, L3)
Displays the 3-phase voltage Total Harmonic Distortion (THD) measurements.
RMS filter current (L1, L2, L3) Displays the 3-phase filter current values as measured by the Harmonic Filter.
Supply current total demand
distortion (L1, L2, L3)
Displays the 3-phase Current Total Demand Distortion (TDD) measurements.
RMS supply current (L1, L2, L3) Displays the 3-phase RMS currents for each line.
Supply contractor (LED) Indicates whether the output to the supply contractor is energized.
Precharge contractor (LED) Indicates whether the output to the precharge contractor is energized.
Model YD Mod D with OptiView Control Center 86