1. Control:
can control single motor, or a group
of up to 20 motors on each channel
2. Range:
200 meters outdoor,
35 meters indoor
3. Battery:
1 x CR2430
4. Power supply:
3 V
5. Dimensions:
80 x 80 x 15 mm
6. Transmitting power:
10 mW
7. Operating temperature:
from 0°C to 50°C
8. Protection degree:
IP 30
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
In order to fully explore available functions of NUXO series please take a moment and read this manual before using the device.
MAGNETIC Deluxe transmitters are compatible with all YOODA brand devices.
NUXO_5RwT
www.sukcesgroup.pl
2. Detailed description
1
5-channel NUXO wall-mounted remote control with timer (NUXO_5RwT)
1. General information
1. For channel to work correctly when remote is set to automatic mode, it has to be activated. If automatic mode is
chosen for the channel and the channel number is flashing, that means device does not work in this mode.
2. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of
smaller than minimal time difference fault message will appear and none of the changes will be saved.
3. Pressing UP or DOWN button in automatic mode will show currently set opening / closing time and symbol of current
process.
4. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average.
5. Batteries should be changed when no channel number is displayed after pressing any button or receiving device stops
reacting to commands.
6. When replacing the battery, pay attention to the correct polarity.
5-channel transmitter
with timer
(front)
5-channel transmitter
with timer
(back)
L1 timer programming
button/C button
battery
Configuration change
button/CHANNEL -
work mode button
UP button
DOWN button
P2
programming button
STOP button
7. When on display all channels are selected remote controls all programmed devices on all channels at the same time.
No programming functions can be performed on group channel. All devices programmed to any other channel can be
controlled on group channel without additional programming.
8. For all devices, that are programmed on all the channels, to work at programmed time, group channel and automatic
mode should be chosen.
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.