YOKOGAWA ZR202S, User Manual, Page: 93 / 163

<8. Detailed Data Setting>
8-12
IM 11M13A01-04E
8.7 Other Settings
8.7.1 Setting the Date-and-Time
The following describe how to set the date-and-time. Automatic calibration works following this setting.
Use parameter code [F10] to set the date-and-time.
Table 8.14 Data-and-time Settings
Switch operation Display Description
> ∧
ENT
F 1 0
Select the parameter code F10.
> ∧
ENT
0 0.01.01
If you touch the [ENT] key, the current date will be displayed. The display
on the left indicates the date - January 1, 2000. To set June 21, 2000,
follow the steps below:
> ∧
ENT
00.0 1 .01
Touch the [ > ] key to move the position of the digit that is flashing to the
right.
> ∧
ENT
00.0 6 .01
Touch the [ ∧ ] key to change to 6.
> ∧
ENT
00.06. 0 1
Touch the [ > ] key to move the position of the digit that is flashing to the
right one digit.
> ∧
ENT
00.06. 2 1
Touch the [ ∧ ] key to change to 2.
> ∧
ENT
00.06.2 1
Touch the [ > ] key to move the position of the digit that is flashing to the
right one digit.
> ∧
ENT
0 7.18
Let the rightmost character flash, and touch the [ > ] key to display the time.
Continuously touch the [ > ] key, then the date and time are alternately
displayed. Displayed on the left is 7:18 a.m.
Omitted here.
> ∧
ENT
14.3 0
Touch the [ ∧ ] key and enter the current time in same way as the date has
been entered, on a 24-hour basis. 2:30 p.m.
Displayed on the left means 2:40 p.m.
> ∧
ENT
14.30
If you touch the [ENT] key, all the digits flash.
> ∧
ENT
14.30
Touch the [ENT] key again to set the time.
> ∧
ENT
F 10
If you touch the [ > ] and [ENT] keys together, the parameter code selection
display appears.
The symbol ( ) indicates that the corresponding keys are being touched, and the light characters indicate flashing.