<4. Installation>
4-1
IM 01C50E01-01EN
4. Installation
4.1 Precautions
• Before installing the transmitter, read the
cautionary notes in section 2.4, “Selecting the
Installation Location.”
• For additional information on the ambient
conditions allowed at the installation location,
refer to subsection 10 “General Specifications.”
NOTE
To connect this transmitter to the Field Wireless
Network, information for connecting to the field
wireless devices needs to be set beforehand.
Refer to subsection 6.4 “Connecting to the Field
Wireless Network.”
IMPORTANT
• When performing on-site pipe fitting work
that involves welding, use care to prevent
outflow of the welding current into the
transmitter.
• Do not use the transmitter as a foothold for
installation.
4.2 Mounting
• The mounting bracket shown in Figure 4.1 is
used for the transmitter and is installed on 50A
(2-inch) pipe. It can be installed either on a
horizontal pipe and a vertical pipe or on a wall.
• To install the mounting bracket on the
transmitter, torque the transmitter fastening bolt
(1) to about 20 to 30 N m.
