YOKOGAWA wt1600, User Manual

Page: 10 / 162

Overview of the GP-IB Interface
1-5
IM 7601010-11E
1
1.5 Setting the Address
Keys
RES
ET
SELEC
T
INPUT
MOTOR SET
RANGE
FILTER
START STOP SYNC SRC
AVG
SCALING
SINGLE STORE SET
REMOTE
MAX HOLD NULL
MENU
HARMONICS
TRIG'D
CURSOR
DISPLAY
FILE
LOCAL MISC
SHIFT
COPY STORE
WAVE
HOLD
UP DATE
RATE
WIRING
INTEGRATOR
INTEG SET RESET
To exit the menu during operation,
press ESC.
ESC
MEASURE
CAL
Procedure
1. Press MISC to display the Misc menu.
2. Press the Communication soft key.
3. Press the Comm Device soft key to display the GP-IB menu.
4. Turn the jog shuttle to set the address.
ESC ESC
Explanation
Carry out the following settings when using a controller to set information that can be
specified through key operation on the WT1600 or when outputting setting parameters or
output waveform display data to the controller.
Setting the Address
Set the address of the WT1600 within the following range for the addressable mode.
0 to 30
Each device that can be connected via GP-IB has a unique address within the GP-IB
system. This address is used to distinguish the device from others. Therefore, when
you connect the WT1600 to a PC, for example, make sure to assign a unique address
to the WT1600.
Note
Do not change the address while the controller or other devices are using the GP-IB system.