7-12
IM 703155-01E
Editing the Sequence Lists of All Output Terminal Sets
You can also edit the element, set the sequence trigger (option), and edit the sequence
list, as described earlier, on the sequence edit screen on which the sequences of all
output terminal sets can be viewed.
Sequence edit screen on which the sequences of all output terminal sets can be viewed
Time
(see section 3.6)
Clock signal frequency
(see section 5.3)
The element selected by the
Element No. of the menu is
highlighted.
Start trigger ON/OFF
(see section 6.1)
Element number
Waveform data
Data length
Sequence list file name
Repeat count
Trigger source
Sampling clock source
Output terminal set
Total number of elements
Excludes waveform data set to
Go to Top.
Sequence trigger setting
Displays “Wait” when the sequence trigger is ON.
Displays blank when the sequence trigger is OFF.
Sending (Loading) Waveform Data to the Waveform Memory
The sequence list contains only the file names of waveform data or no signal periods.
To actually generate the waveform, the waveform data must be loaded in the waveform
memory. To load the waveform data to the waveform memory according to the order in
the sequence list, all of the waveform data registered in the sequence list must be stored
on the VB8300 internal hard disk, CF card, or USB memory.
Note
•
When loading to the waveform memory, the loading process is faster using raw data because
the data size is smaller.
•
If the ASCII data does not contain RMS values or information about the number of points, the
loading process may take longer than 10 minutes.
•
The sequence list file contains the path and name of the waveform data files. It does not
contain the actual waveform data. If the waveform data files do not exist at the registered
path destination (relative path), an error occurs when the sequence list file is loaded.
•
You can edit the sequence list until the number of elements reaches 128 or the data length of
the waveform data of all elements reaches the memory length of the VB8300 model that you
are using.
7.2 Sequence Editing and Loading Waveform Data to the Waveform Memory
