YOKOGAWA VB8300, User Manual

Page: 55 / 221

5-3
IM 703155-01E
Setting the Output Waveform
5
5.3 Setting the Clock Frequency
Procedure
To exit the menu during operation, press ESC located above
the soft keys.
In the procedural explanation below, the phrase “ rotary knob
& SELECT ” and “ numeric keys & ENTER ” may be used.
These phrases indicate procedures for selecting/setting items
and entering values, character strings, and units. For details
on the procedure, see section 3.7 or 3.8.
BACK
SPACE
DISPLAY
ON/OFF
KEY
LOCK
INITIALIZE
HDD
OPTION
PRINT
MISC
FILE CLOCK
MANUAL
TRIG
WAVE SEQ TRIG DISP
OUT 1 OUT 2 OUT 3 OUT 4
REMOTE
UNLOCK
OFF
PRESET
SHIFT
1. Press CLOCK . The Clock menu appears.
2. Press the Frequency soft key.
3. Enter the clock signal frequency using numeric keys & ENTER .
Explanation
The VB8300 generates waveforms by synchronizing to the internal or external clock
signal. Of the two clock signals, you can set the frequency of the internal clock signal.
Selectable range: 300.000 kHz to 300.000000 MHz (in 1 Hz steps)
Default value: 1.000000 MHz
• You can select the internal or external reference signal for the 10-MHz reference
signal on which the internal clock signal based. For the procedure of selecting the 10-
MHz reference signal, see section 5.1.
• When the external clock signal is selected, the clock frequency specified on the
VB8300 is invalid. For the procedure of selecting the clock signal, see section 5.2.
Note
If you changed the clock frequency while waveform generation was in progress, start
waveform generation from the start of the sequence list.