YOKOGAWA TB820D, User Manual, Page: 40 / 87

<4. SETTING PARAMETERS>
4-7
IM 12E01B30-02EN 2nd Edition : June 09 , 2021-00
4.2.6 Calibration setting others
Zero, slope, Sens.factor is changed manually.
Do not change those setting except for resetting value. Go to sensor detail screen to check the
setting as reference.
4.3 Diagnosis setting
4.3.1 Light source diagnosis
Select Light source diagnosis On/Off. See 5.3 for details.
4.3.2 Dried condition diagnosis
Select Dried condition diagnosis On/Off. See 5.3 for details.
4.3.3 Operating days
Set each counts of parameter enabled/disabled. If you want to confirm the value of operation
days, enable the function. However, even if you set it disabled, the operating day counts
internally. See 5.3 for details.
4.4 Communication setting
n
Sensor connection address
You can change Modbus address. After changing Modbus address, you need to change the
configuration of the converter that connects to the system.
To change the converter setting,
Converter menu > Setting > Converter setting > Advanced settings > MODBUS setting >
Sensor Address setting (S)
See FLXA402T Operation of Converter IM 12A01F01-03EN