13-2
IM 701240-01E
Recalling the Data
3.
Turn the
jog shuttle
to select the memory number (No.) of the storage
destination.
Note
Select a memory number in which setup data was stored by the procedure described in
“Storing the Setup Data” on the previous page. An error will occur if you select a memory
number in which no setup data is stored and execute the recall operation.
Executing the Recall Operation
4.
Press the
Recall Exec
soft key to execute the recall operation.
Explanation
Data That Is Stored
The setup data of each key existing at the time of the storage operation can be saved.
However, setup data such as the date/time, communications, and SCSI ID numbers is
not saved.
Number of Memories
Three sets of setup data can be stored in memories numbered 1 to 3.
If the setup data is already stored at the selected number, the previous data is
overwritten.
Comment
A comment of up to 160 characters can be added and saved. Comments are optional. All
characters (including spaces) can be used.
Data That Is Recalled
Select a memory number 1 to 3 in which setup data is stored. You can only recall data
from a memory in which setup data is stored.
Note
•
If you execute the recall operation, the settings cannot be set back to those that existed
before the recall operation.
•
The stored setup data is not cleared even if you initialize the settings. The stored setup
data is cleared if you turn ON the power switch while holding down the RESET key.
13.1 Storing and Recalling the Setup Data
