Making Preparations for Measurements
3-39
IM 720120-01E
1
2
3
4
5
6
7
App
Index
3.11 Connecting Sensors to the Frequency Module
Sensors and Signal Output Sources That Can Be Connected
The table below shows the sensor and signal output source that can be connected.
Appropriate input presets are provided for each sensor and signal output source. For the
procedure to set presets, see the
Acquisition Software User’s Manual IM720120-61E.
Sensor and Signal Output Source
Preset Name
5-V logic signal, 5-V output sensor, and sensor with TTL output
Logic 5V
3-V logic signal and 3-V output sensor
Logic 3V
12-V driven relay/sequence circuit and 12-V driven sensor
Logic 12V
24-V driven relay/sequence circuit and 24-V driven sensor
Logic 24V
Sensor/Encoder that outputs positive and negative voltages and sensor
that outputs sine waves
ZeroCross
100-VAC power supply (connected through the isolated probe 700929 or
passive probe 702902)
AC100V
200-VAC power supply (connected through the isolated probe 700929 or
passive probe 702902)
AC200V
Power-generating electromagnetic pickup
EM Pickup
Open collector output (0 to 5 V output) and contact output
Pull-up 5V
WARNING
If over-range is indicated on the display of SL1000, the SL1000 may be receiving
a voltage higher than the observed waveform or measured waveform values. To
prevent electric shock, change the measuring range so that the entire amplitude
of the waveform is displayed within the waveform display area of the SL1000
Acquisition Software, and check the input voltage level.
Range Out Slot1_L >>
Channel
U: Upper channel of the slot
L: Lower channel of the slot
Slot No.
Indicate “>>” when over-range is occurring on multiple channels.
Indicates the smallest number among the slot
that over-range is occurring on.
French
AVERTISSEMENT
En cas de dépassement de plage indiqué à l’écran du SL1000, ce dernier risque
de recevoir une tension supérieure à la forme d’onde observée ou aux valeurs
de forme d’onde mesurées. Pour éviter tout choc électrique, modifiez la plage
de mesure afin que l’amplitude totale de la forme d’onde s’affiche dans la zone
d’affichage correspondante du logiciel d’acquisition SL1000, et vérifiez la tension
d’entrée.
Range Out Slot1_L >>
Canal
U : canal supérieur du logement
L : canal inférieur du logement
N° de canal
Indique >> lorsque le dépassement de plage concerne plusieurs
canaux.
Indique la valeur la plus faible du logement présentant un
dépassement de plage.