IM 12D03D02-01E
4-3
4
.
Keypad and Display Functions
4.2 Display Items
Display items and their descriptions are provided below.
Remaining battery life display
Manual range setting mode
Temp. compensation setting mode
Data save mode
HOLD mode
Calibration with std. solution
Cell constant set mode
(1) Remaining battery life display
Indicates the level of the remaining battery life stepwise.
means that
there is plenty of life left. A flashing
means that the batteries are low and
need to be replaced immediately.
To replace the batteries, first press
POWER
key to turn off power and make
sure the display has been turned off, and then replace referring to Section 2.1,
“Installing the Batteries.”
(2) Temperature compensation setting mode
This mark appears when temperature compensation is being set (refer to
Section 4.3 (2), “Temperature compensation setting (t.Co) panel”).
(3) Manual range setting mode
Normally autoranging is used, and optimum range is selected automatically, but
if fixed (manual) range setting is used then this mark appears (refer to Section
4.3 (3), “Range selection (rnG) panel”).
(4) Data save mode
Appears when measured data are stored or when stored data are accessed
(refer to Section 4.1, “Keypad Functions,” and Section 4.3 (1), “Display stored
data (dAt) panel”).
(5) HOLD mode
Appears while measured data are being held temporarily (refer to Section 4.1,
“Keypad Functions”).
(6) Calibration with standard solution
This mode display appears when the calibration with standard solution is
conducted (refer to Section 4.3 (5), “Calibration with standard solution (CAL)
panel”).
(7) Cell constant set mode
This mode display appears when the sensor cell constants are manually set
(refer to Section 4.3 (4), “Cell constant setting (C.C) panel”).
