YOKOGAWA MuR10000, Manual

Page: 138 / 272

IM 04P01B01-01E
6-18
Setting the Feed Amount, Lot Number Update, and Ejection of Pen Offset
Compensating Data
Set=Batch
Mode=Start
Detail=Action
Feed= 0
Auto inc.=On
(Only when the Mode is End or End 2
and the lot number is 4 or 6 digits)
(Only when the Mode is End or End 2
and pen model offset compensation is On)
(Only when POC output is On)
Batch action
Setting complete
Select Start, End, Start2, or End2.
Select Action.
Set the chart paper feed amount before
Start printout and after End printout.
Select whether to update (+1) lot number
when recording stops. Select On or Off.
The new setting takes effect.
Batch=Detail
POC output=On
Select whether to eject the pen offset
compensating data when recording
stops. Select On or Off.
POC speed=C.Speed
Select the chart speed when ejecting the
pen offset compensating data.
ESC/?
Select Detail.
Explanation
Batch No.
You can enter up to 26 characters.
The following are the characters that can be used.
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω,
2
,
3
, .), and space
Lot No.
Enter using a 4 or 6 digit number. Select which number of digits to use (4 or 6) under
“Lot No.” in Basic Setting mode.
Mode
Select Start, End, Start 2, or End 2. Start 2 and End 2 become available when you
enable “Dual comment” in Basic Setting mode.
Line No.
1 to 5 lines can be printed out.
Comment
You can enter up to 32 characters.
The following are the characters that can be used.
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω,
2
,
3
, .), and space
6.14 Setting Up Start Printout and End printout (/BT1 Option)