YOKOGAWA FIELDEYE II Series, User Manual

Page: 66 / 112

IM 85A7C03-16E
7-3
< 7. Accessing the Video stream>
7.1.4.
Title Bar
Title Bar in the Home window shows fundamental information that are Server Name, Model Name,
and firmware versions which are shown below: the Server Name can be changed(Please refer to
7.4.1).
(1) Firm Version (HDCTRL):
A displayed numbers of 6-columns: AB.CD.EF (where A to F are natural numbers) shows a version
of Ctrl module firmware being embedded into HDCTRL_BD.
(2) Firm Version (ENC):
A displayed numbers of 3-columns: A.BC (where A, B and C are natural numbers) shows a version
of Encoder module firmware being embedded into ENC_BD.
7.1.5.
Status Indicator
Status indicators of 4 at an Upper-right-corner are updated every 60 seconds. These indicators are
provided by an internal video encoder board (shown as
ENC_BD of Fig.3-2 in the block diagram).
Figure 7-3 Example of the Status Indicator
(1)
NETWORK
Displaying Detected status(s)
RED: CGI (Common Gateway Interface)-communication via the IP network failed
Please check IP connection between FC33 and the PC which is executing Web
browser.
Next, reboot the camera and PC. If still the RED displayed, please contact
Yokogawa
’s sales distributor or sales office.
GREEN: A web access (CGI communication /CGI call) to this camera by Web browser has
succeeded.
(2)
PWR
Displaying Detected status(s) :
RED: An error status(s) has been detected at the power unit of FC33.
Voltage fluctuation exceeding 10 percent had been detected at DC5V or DC12V against
the rated voltages
Reboot the camera and check the indicator again. If the RED was still displayed, in
spite of the normal AC power inputting, please confirm operation LOG file(s) and
get it.
To obtain such LOG file(s), please refer to section 7.5.4 .
And contact Yokogawa
’s sales distributor or sales office.
GREEN: Each DC voltage output in the main body is being into the rated range (±10%).