YOKOGAWA FIELDEYE II Series, User Manual

Page: 56 / 112

IM 85A7C03-16E
5-27
<5. Cabling and Installing>
5.8.
Return to Zero Position
The camera can be returned to the zero position from the controller or PC. Figure 5-35 below shows
the zero position. The camera automatically returns to the zero position by powering off and then on
the camera body.
After the camera returns to the zero position, the zoom position comes to the wide end, the focus
comes to Auto, and the Auto Exposure mode and the turning speed are maintained as previously set.
The turning speed is maintained if the specified Return to Zero Position command is used. The
speed is fixed at 30°/sec immediately after the turning on the power.
CAUTION
During the camera returns to the zero position, do not remotely operate the camera from the
PC(Client). If you attempt to do so, the camera may fail to normally returns to the zero position.
Pendant que la caméra revient à la position zéro, ne faites pas fonctionner la caméra à distance
depuis le PC (client). Si vous essayez de le faire, la caméra risque de ne pas revenir
normalement à la position zéro.
Figure 5.33 Zero position of FC33