YOKOGAWA FG420, User Manual

Page: 117 / 180

103 IM FG410-01EN
4.8.6 Setting amplitude sweep
For the manipulation methods that are common with the sweep setting screen, refer to p.87 and
p.90 .
a) Amplitude sweep example
The following is an example of continuous, linear shuttle sweep.
Shuttle sweep
Sweep value
Output signal
Start value
Stop value
Sweep time Sweep time
b) Selecting amplitude sweep
When [Mode] (oscillation mode) is set
to [Sweep] (sweep), set [Type] (sweep
type) on the 2nd page of the setting
screen to [Amptd] (amplitude).
c) Waveforms for which amplitude sweep is not possible
Amplitude sweep is not possible for DC.
d) Setting items required for amplitude sweep
Set the following items on the 2nd page of the setting screen. The amplitude settings on the 1st page
of the setting screen are disabled.
• Start amplitude [Start]
• Stop amplitude [Stop]
• Sweep time [Time]
This is the transition time from the start amplitude to the stop amplitude.

p.91
• Sweep mode [SwpMode]
Continuous, single-shot, and gated single-shot can be chosen from.

p.91
• Sweep function [SwpFctn]
One-way/shuttle can be chosen from.

p.90
Setting with [Center] (center amplitude) and [Span] (span amplitude) instead of the start amplitude
and stop amplitude is also possible.

p.90
When the sweep mode is single-shot or gated single-shot, [Trig] (trigger condition) must be set.

p.94
Select [Amptd] in
[Type] and then
press the ENTER
key.
4.8 Sweep Setting and Manipulation