4.9 Burst Setting and Manipulation
109
IM FG410-01EN
4.9.3 Trigger burst
Oscillation with the specified wave number is done each time a trigger is received.
Settings and manipulations are done on the Oscillator setting screen. “Oscillator” is
displayed at the top left of the oscillator setting screen. When another screen is displayed,
pressing the
MENU key displays the top menu, so select [Oscillator] and then press
the
ENTER key.
a) Trigger burst example
The following example is for mark wave number (oscillation wave number) = 4, oscillation
start/stop phase = 30°, stop level = off.
b) Setting the oscillation mode to trigger burst
Set [Mode] (oscillation mode) to [Burst] on
the Oscillator setting screen. The oscilla-
tion mode is switched to the burst oscilla-
tion mode as a result.
In the burst oscillation mode, the setting
screen consists of two pages, which can
be toggled with the
NEXT key.
Next, set [BrstMode] (burst mode) on the
2nd page of the burst oscillation mode
setting screen to [Trigger] (trigger burst).
MENU
ENTER
Oscillation start/stop phase
30°
Trigger signal
Output signal
Trigger
delay time
Trigger
delay time
No new trigger accepted
in this interval
Select [Burst] in
[Mode] and then
press the ENTER
key.
NEXT
Select [Trigger] in
[BrstMode] and
then press the
ENTER key
