YOKOGAWA DTSXL, User Manual, Page: 98 / 289

< PART – B Software >
B-15
IM 39J06B40-01EN 14th Edition: May 30, 2022
B1.5. System Configuration
You can perform network and other system configurations from any Web browser
running on a PC.
TIP
For Windows 8, Windows 8.1, or Windows 10 users, use the desktop app version of the Internet
Explorer as the Web browser.
SEE ALSO
For details on network configuration, see Chapter B6, “System Configuration”.
1. Connect the DTSX3000 and a PC using an Ethernet cable.
Figure Connection for System Configuration
Boot up the DTSX3000 in maintenance state.
To boot up the system in maintenance state, put the system in maintenance mode
selected state when it transits to boot mode selection state immediately after power up.
If the system is left in this state for more than 5 seconds, it goes into maintenance state.
The state of the DTSX can be determined from the state of its LED indicators.
Boot mode selection state
: HRDY and RDY blink fast.
Maintenance mode selected state : HRDY blinks fast; RDY is off.
SEE ALSO
For details on the system operating states, see Subsection B4.1, “Operation Overview.”
2. Run a Web browser on the PC and enter the following text in the URL:
http://<hostname or IP address of DTSX3000>/mnt/
On the displayed user authentication dialog, enter a valid user name and
password.
The following user is pre-registered in the factory.
Username: dtsx
Password: YOKOGAWA
User authority: Administrator (admin)
After user authentication succeeds, the top maintenance window is displayed.