YOKOGAWA DTSXL, User Manual, Page: 44 / 289

< PART – A Hardware >
A-21
IM 39J06B40-01EN 14th Edition: May 30, 2022
A4.2. Installing Other Modules onto the Base
Module
This section describes the procedure for installing a power supply module, a DTSX3000
Distributed Temperature Sensor module, an Optical Switch module and a CPU module
onto a base module.

Installation Position of Each Module
This section describes the positioning of the modules for installation to the base module.
Figure Installation Positions of DTSXL System Modules
Table Installation Positions of DTSXL System Modules
Module Installation Position Remarks
Power supply module P1 Module is to be installed in slot P1.
CPU module (*1) Slots 1 to 2 Each module occupies 2 slots.
DTSX3000 Slots 3 to 8 Each module occupies 6 slots.
Optical switch module Slots 9 to 10 Each module occupies 2 slots

Installation Restrictions and Precautions
●
Power supply module installation restrictions
Redundant configuration is not allowed for the power supply module. Does not use slot
P2.
●
CPU module installation restrictions
Redundant configuration is not allowed for the CPU module.
●
STARDOM module installation restrictions and precautions
STARDOM modules other than the power supply modules (NFPW426, NFPW441,
NFPW442 or NFPW444) and CPU module (NFCP050) cannot be installed to the base
module for DTSX3000.
Do not install other STARDOM modules.
●
Optical switch module installation precautions
When installing the optical switch module, to prevent it from contacting with the front
panel of the distributed temperature sensor, always install the sensor first. Similarly, on
removal, always remove the optical switch module first. When installing the optical
switch module, ensure that the gasket of the front panel is not loosened.
P1 P2 1 2 3 4 5 6 7 8 9 10
Slot numbers