YOKOGAWA DTSXL, User Manual, Page: 160 / 289

< PART – B Software >
B-77
IM 39J06B40-01EN 14th Edition: May 30, 2022
・
Interval
Specify a value from 0 [s] to 3600 [s] in units of 1 [s]. The preceding sample screen
capture defines the following sequence:
Ch1 measurement
→
wait until 60 seconds after beginning of Ch1 measurement
→
Ch2 measurement
→
wait until 50 seconds after beginning of Ch2 measurement
→
Ch3 measurement
→
wait until 40 seconds after beginning of Ch3 measurement.
If the execution time for measurement is longer than the specified measurement
interval, the next measurement begins immediately after the current measurement
ends.
SEE ALSO
For details on double-ended measurement, see Subsection B1.1.2, “Double-ended Measurement
Settings.”
Tip
- To configure Ch2 to Ch16, you need to purchase additional optical fibers.
- The same channel cannot be selected more than once in the sequence table.
B7.2.2.
Sequence Control
By specifying the sequence mode, repetition mode, sequence interval and sequence
start time, you can define the sequence control conditions for the sequence table
described in Subsection B7.2.1, “Sequence Table Settings.”
No1
Ch1 measurement
No2
[sec]
Ch2 measurement
No3
60 [sec]
Ch3 measurement
50 [sec] 40 [sec]