YOKOGAWA DTSXL, User Manual, Page: 149 / 289

< PART – B Software >
B-66
IM 39J06B40-01EN 14th Edition: May 30, 2022
B6.5. Application Configuration Items
B6.5.1. Power Save Settings
Using power save settings, you can configure the power save function, which suspends
power supply to measurement hardware when no measurement is being done. When
power save is enabled, the system behaves as follows:
- After power on, the system goes into wait state for a start measurement instruction.
If no start measurement instruction or start self-test instruction is received after 5
み
minutes have elapsed, the system goes into power save mode.
The system exits from power save mode when it receives a start measurement
instruction or start self-test instruction.
- The system goes into power save mode immediately after measurement ends. It
exits from power save mode thereafter 5 minutes before the next measurement start
time according to the sequence settings.
To configure power save, click on Power Save on the side menu to display the following
screen. The settings are applied after reboot.
wait state for a start
measurement
Command to start
measurement
time
1
st
measurement
5 minutes
2
nd
measurement
5 minutes
nth
t
time
(n+1)th
measurement
(n+2)th
measurement
Power
save
mode
Power
save
mode
5 minutes
Power
save
mode
5 minutes
Power
save
mode