7-1
IM DR231-01E
Executing Recording
7
7.1 Starting Dot Printing, Digital Printing and
Printing in Logging Mode
D I S P
M O D E
P R I N T
F U N C
I N S
D E L
R A N G E A L A R M
S E T
C H A R T
E N T E R
F E E D
M. F U N C 1
M. F U N C 2
ALARM
CHART
KEYLOCK
R E C O R D
E S C
RECORD
To start recording
Press the RECORD key. The status display [RECORD] lights.
To stop recording
Press the RECORD key once again. The status display [RECORD] turns off.
To feed the recording paper
Press the FEED key.
Starting dot printing, digital printing, and recording in logging mode
• See Chapter 6, “Setting.”
• Event/action functions can also be used to perform the above printing and recording (see Page
9-1).
Feeding the recording paper
Press the FEED key to feed the recording paper. Even if the FEED key is pressed while
recording, the paper is fed without stopping the recording.
Notes on starting recording
The carriage will stop temporarily at the left or right side for each line as shown below.
• When printing in logging mode or manual printing:
Printing direction
Channel no./TAG selection
Temporary stop (in seconds)
Horizontal
Channel
4 (0)
TAG of 7 to 8 characters
3 (1)
TAG of 9 to 16 characters
5 (2)
Vertical
Channel
2 (0)
TAG of 7 to 16 characters
3 (0)
The values in ( ) are for the DR130.
• List printing
Temporary stop: For 0.5 seconds
Note
In the case of the DR130, the carriage does not come to a pause in manual or list printing.
Summary of Contents for DR130
Page 12: ...10 IM DR231 01E ...
